How to Insert Your Swimsuit Paddings?

Removable pad inserts on swimsuits and sports bras are a necessary evil—but they really are evil. On the one hand, they’re great because they add a little snugness, give some extra lift and oomph, and prevent you from nipping out in the gym and on the beach.It’s that very fact that makes them so evil, though: The pads come out of their little insertion holes in the wash. They get flipped and turned around in the garment during normal wear. They are a pain. Here’s how to finally keep them in check.

Widen the insertion holes
If your pads keep coming out in the washing machine, it might seem counterintuitive to make the holes wider, but consider that doing so makes reinserting the foam easier in the end. Use a scissor to cut a line down the center of the internal piece of fabric (the piece sewn to the back to hold them in place). Then, you should sew around the new raw edges to prevent fraying or the hole from expanding. 

Pin the pads in place before washing
If you don’t want them to come out in the wash at all, just use safety pins to keep the pads in place before loading them into your machine. Be sure to remove the pins before wearing the bra or swimsuit again, of course, but otherwise, this is one of those solutions that seems almost too obvious once you think of it.
You can also just sew them in place from the get-go, if you want to. Make a few simple stitches at the top and bottom of the pad while it’s in its pouch, taking care to only sew it to that internal panel and not let your needle poke through to the front of the garment.

Roll the pad before reinserting it
For whatever reason, whenever the pads of my sports bras come out in the wash, I always try to force them back through their tiny insertion hole flat, squishing them as I go and creating creases that then make them bunch up when I wear them. I’ve started rolling them up and sliding them through the hole about 90% of the way, then letting them unfurl while still holding a little portion outside of the garment and adjusting them once they’re flat inside.